Figure 35-8 Restore Using Ftp Session Example; Figure 35-9 System Maintenance: Restore Configuration; Figure 35-10 System Maintenance: Starting Xmodem Download Screen - ZyXEL Communications ZyWALL 5 User Manual

Press [ENTER] when prompted for a username.
3.
Enter your password as requested (the default is "1234").
4.
Enter "bin" to set transfer mode to binary.
5.
Find the "rom" file (on your computer) that you want to restore to your ZyWALL.
6.
Use "put" to transfer files from the ZyWALL to the computer, for example, "put config.rom rom-
7.
0" transfers the configuration file "config.rom" on your computer to the ZyWALL. See earlier in
this chapter for more information on filename conventions.
Enter "quit" to exit the ftp prompt. The ZyWALL will automatically restart after a successful
8.
restore process.
35.4.2 Restore Using FTP Session Example
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to section 35.3.5 to read about configurations that disallow TFTP and FTP over WAN.
35.4.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure shown next.
Procedures using other serial communications programs should be similar.
Display menu 24.6 and enter "y" at the following screen.
1.

Figure 35-9 System Maintenance: Restore Configuration

The following screen indicates that the Xmodem download has started.
2.

Figure 35-10 System Maintenance: Starting Xmodem Download Screen

Run the HyperTerminal program by clicking Transfer, then Send File as shown in the following
3.
screen.
Firmware and Configuration File Maintenance

Figure 35-8 Restore Using FTP Session Example

Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...
CCCCCCCCC
ZyWALL 5 Internet Security Appliance
35-7