Figure 29-2 Menu 12. 1: Edit Ip Static Route; Table 29-1 Menu 12. 1: Edit Ip Static Route - ZyXEL Communications ZyWALL 5 User Manual

ZyWALL 5 Internet Security Appliance
`The following table describes the IP Static Route Menu fields.
FIELD
Route # This is the index number of the static route that you chose in menu 12.
Route Name Enter a descriptive name for this route. This is for identification purposes only.
Active This field allows you to activate/deactivate this static route.
Destination IP This parameter specifies the IP network address of the final destination. Routing is always
Address based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
IP Subnet Mask Enter the IP subnet mask for this destination.
Gateway IP Enter the IP address of the gateway. The gateway is an immediate neighbor of your
Address ZyWALL that will forward the packet to the destination. On the LAN, the gateway must be a
router on the same segment as your ZyWALL; over the WAN, the gateway must be the IP
address of one of the remote nodes.
Metric Enter a number from 1 to 15 to set this route's priority among the ZyWALL's routes (see the
Metric section in the WAN and Dial Backup Setup chapter). The smaller the number, the
higher priority the route has.
Private This parameter determines if the ZyWALL will include the route to this remote node in its
RIP broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast. If
No, the route to this remote node will be propagated to other hosts through RIP broadcasts.
Once you have completed filling in this menu, press [ENTER] at the message "Press ENTER to Confirm..." to
save your configuration, or press [ESC] to cancel.
29-2
Menu 12.1 - Edit IP Static Route
Route #: 2
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to CONFIRM or ESC to CANCEL:

Figure 29-2 Menu 12. 1: Edit IP Static Route

Table 29-1 Menu 12. 1: Edit IP Static Route

DESCRIPTION
IP Static Route Setup