Test (Menu); Remote Port User Interface - Radyne MM200 Installation And Operation Manual

User Interfaces
FW4459--
FW4459--

4.4.10 TEST (Menu)

The Test Screens are listed below:
Screen Name
LED TEST
MUX DMX LOOP
RF LOOPBK
CARRIER
PRBS:
REMOTE TAPS
AGC BW

4.5 Remote Port User Interface

The Remote Port of the MM200 allows for complete control and monitor functions via an RS-485
Serial Interface.
Control and status messages are conveyed between the MM200 and the subsidiary modems, and
the host computer using packetized message blocks in accordance with a proprietary
communications specification. This communication is handled by the Radyne Link Level Protocol
(RLLP), which serves as a protocol 'wrapper' for the M&C data.
Complete information on monitor and control software is contained in the following sections.
4-30
Firmware Version
Firmware Date
Selections and Descriptions
{On, Off}
Illuminates all LEDs on front panel.
{Normal, Mux Dmx Loop, Mux, Dmx
LVDS, Modem LVDS, Repeater}
Tests multiplexer and demultiplexer
function.
{NORMAL, LOOPBACK}
Tests modulator and demodulator
function.
{Normal, CW, Offset 1 Hz, 100 kHz, 3.5
MHz, Sweep Up, Sweep Dn}
Sets the carrier to normal pure carrier
output, or sweep test modes.
15 15 23 23
{None, 2 , 2 M, 2 , 2
Breaks the data path and inserts a pseudo
random sequence into the modulators.
'None' is used for normal operation, the
others are for Radyne Inc. configuration.
{NORMAL, 1:1, 1:10, 1:100}
Remote Tap Enable
{6}
Set to 6 for normal operation.
MM200 High-Speed Microwave Modem
RO
RO
L0
RW
RW
RW
RW
RW
M}
RW
RW
TM086 - Rev. 4.1
RO RO
RO RO
L1 L2
RW RW
RW RW
RW RW
RW RW
RW RW
RW RW
RW RW