Section 4 - User Interfaces; User Interfaces; Front Panel User Interface - Radyne MM200 Installation And Operation Manual

MM200 High-Speed Microwave Modem

User Interfaces

4.0 User Interfaces
There are four user interfaces available for the MM200. These are:

Front Panel Control.

Command Interface Control.

Terminal Interface

Ethernet SNMP
Any of these methods may be used separately or together to monitor and control the MM200.
Each of these interfaces and their respective methods are discussed separately below.

4.1 Front Panel User Interface

The front panel of the MM200 allows for complete monitor and control (M&C) of all parameters
and functions via a keypad, LCD display and status LEDs.
The front panel layout is shown in Figure 4−1, showing the location and labeling of the front panel.
The front panel is divided into four functional areas: the Front Panel LCD Display, the Cursor
Control Arrows, the Numeric Keypad, and the Front Panel LED Indicators, each described below
in Table 4-1.
Figure 4-1. MM200 Front Panel Controls and Indicators
Item No.
1 Front Panel LCD Display
2 Cursor Control Arrows
3 Numeric Keypad
4 Front Panel LED
Indicators
TM086 - Rev. 4.1
Table 4-1
Description
Displays MM200 Operating parameters and
Configuration data.
Controls the up, down, left, and right movement
of the cursor in the Front Panel LCD Display.
Allows entry of numeric data, and the Clear and
Enter function keys.
Refer to Section 4.1.2 for an itemized description
of these LEDs.
User Interfaces
Function
4
4-1