Latched Alarms; Clear Alarms; System (Menu) - Radyne MM200 Installation And Operation Manual

User Interfaces
MINOR INT2 (menu)
MINOR INT3 (menu)
MINOR INT4 (menu)
COMMON (menu)
GLUE HW FPGA
TEST HW FPGA

4.4.8.2 Latched Alarms

The Latched Alarm Screens are the same as Active Alarms Screens. Refer to Section 4.1.7.1 for
descriptions.

4.4.8.3 Clear Alarms

The Clear Alarms Screen clears the currently latched alarms.

4.4.9 SYSTEM (Menu)

The System Screens are listed below:
Screen Name
CONTROL MODE
USER MODE
DEBUG MODE
LAST RATE
FREQ PLAN
APC ENABLE
MAX MODULATION
4-28
Buffer clock PLL not locked.
Refer to MINOR INT0 (menu) for
descriptions.
Refer to MINOR INT0 (menu) for
descriptions.
Refer to MINOR INT0 (menu) for
descriptions.
An alarm that affects both transmit and
receive.
FPGA failure. Refer to Section 6.1.
FPGA failure. Refer to Section 6.1.
Selections and Descriptions
{Front Panel, Computer}
Allows the user to choose whether the
system is controlled from the Front Panel
or via a remote computer.
{Level 0, Level 1, Level 2}
Depending upon the setting, allows the
user to have access to all system
parameters, or operate at Levels 1 or 2
control.
{Off, On}
Allows the user to turn on or off the Debug
Mode
{Symbol, Data, Auto}
Allows the user to give precedence to
symbol rate or data rate (which remains
constant while the other varies). Auto
allows both to vary.
Controls the user frequency plan.
{Off, On}
Controls APC subsystem.
{QAM4, QAM16, QAM32, QAM64,
QAM128, QAM256}
Controls the maximum allowable
modulation for automatic calculations.
MM200 High-Speed Microwave Modem
RO
RO
RO
L0
RW
RW
RW
RW
RW
RW
RW
TM086 - Rev. 4.1
RO RO
RO RO
RO RO
L1 L2
RW RW
RW RW
RW RW
RW RW