Table of Contents
Advertisement
User Interfaces
3.
Re-enter the new password to verify desired setting.
4.
Select OK
4.25 Modem MM200 High-Speed Microwave Modem Ethernet Address
1.
The Modem MM200 High-Speed Microwave Modem Ethernet Address is configured at
the factory. It is a unique Radyne Inc. equipment identifier.
Example: 0010650903EB
Do not modify the Ethernet Address.
changed.
4.26 Modem IP Address
1.
Select 33, 'Modem IP Addr'. Enter the Modem Internet Address in dot notation and press
<Enter>. Please consult your network administrator for valid addresses.
Example - 192.168.0.35
2.
The IP Address that is selected will be used for the Ethernet Test that follows.
4.27 Server Ethernet Address
This section refers to the boot host.
1.
Select 34, 'Server Eth Addr'. Enter the Server 12 Digit Ethernet Address and press
<Enter>. Zero out this address if not known at this time. The system will resolve it
dynamically at run time.
Example: 0FD0640203ED or 000000000000
4.28 Server IP Address
This section refers to the Host that will be used to optionally boot the MM200 on power-up. The
host should be acceptable to the transport layer. In other words, the transport layer needs to be
able to open a connection to the entity specified by the server IP Address field.
1.
Select 35, 'Server IP Addr'. Enter the Server Internet Address in dot notation and press
<Enter>. Please consult your network administrator for valid addresses.
Example: 192.168.0.50
2.
The IP Address that is selected will be used for the Ethernet Test that follows.
4.29 Server Host Name
4-46
MM200 High-Speed Microwave Modem
Major problems may result if
TM086 - Rev. 4.1
Advertisement
Table of Contents
Troubleshooting
