Radyne MM200 Installation And Operation Manual page 119

MM200 High-Speed Microwave Modem
<1> Channel Latched
Major Alarm Status
<1> Channel Latched
Minor Alarm Status
<4> Channel Baud Rate
<4> Channel Offset
Frequency
<4> Channel AGC
Integrator
<4> Channel SNR
<4> Channel CBA
<4> Channel UBA
<2> Input Level
<4> Pre FEC BER
<4> Post FEC BER
Opcode: <0x20BD>
<1> Major Alarm1
<1> Major Alarm2
TM086 – Rev. 4.1
Bit 3 = FIFO empty status
Bit 4 = Sync lock status
Bit 5 = FIFO reload status
Bit 6 = FIFO pos status
Bit 7 = Track fault status
0 = Pass, 1 = Fail
Bit 0 = Demod daughter board FPGA status
Bit 1 = RF PLL lock detect status
Bits 2 - 7 = Spare
0 = Pass, 1 = Fail
Bit 0 = QAM lock status
Bit 1 = FEC lock status
Bit 2 = FIFO full status
Bit 3 = FIFO empty status
Bit 4 = Sync lock status
Bit 5 = FIFO reload status
Bit 6 = FIFO pos status
Bit 7 = Track fault status
7000000 - 200000000
Binary value in Hz
AGC integrator
Signal-to-noise ratio, 00.00 - 99.00 dB, implied decimal point
Correctable blocks accumulator
Uncorrectable blocks accumulator
Channel input level in dBm. Signed implied decimal point
(-265 means –26.5 dBm)
Floating point format following IEEE Standard 754*
Floating point format following IEEE Standard 754*
* Refer to Appendix C for IEEE Standard 754 – Floating Point
Numbers
Query a demodulator's status
Query Response
0 = Pass, 1 = Fail
Bit 0 = Glue Logic FPGA Fail
Bit 1 = Data FPGA Fail
Bit 2 = Signal Lock Detect
Bit 3 = Sync Lock Detect
Bit 4 = Deframer clock PLL lock detect
Bit 5 = Diversity FPGA fail
Bits 6 – 7 = Spare
0 = Pass, 1 = Fail
Appendix A
A-19