Section 7 - Technical Specifications; Introduction; Specifications; Options - Radyne MM200 Installation And Operation Manual

MM200 High-Speed Microwave Modem
Technical Specifications

7.0 Introduction

This section defines the technical performance parameters and specifications for the MM200
High-Speed Microwave Modem.

7.1 Specifications

Total Data Rate
Note Interface selection may limit maximum data rate.
Total Baud Rate
IF Channels
IF Channel Baud Rate
Mux/Demux
Modulation
FEC
FEC/Mux Overhead
Adaptive Equalizer
IF Range
IF Return Loss
Tx Output Power
Spurious Output
Rx Input Power
Frequency Stability
Carrier Acquisition
Rx Data Buffer
Remote Control
Chassis Size
Power
Environmental
Compliance

7.2 Options

TM086 - Rev. 4.1
Variable from 1 to 200 Mbps total in 1 bps steps
3.5 – 7, 7 – 14, 10.5 – 21, or 14 – 28 Mbaud depending
upon number of IF channels installed
1 to 4
3.5 to 7 Mbaud Per Channel
One to four* data channel DVB compliant
4, 16, 32, 64, 128, 256 QAM*
204/188 Reed Solomon
204/184 (204/188 for DVB Framed Interface)
12 tap DFE and 8 tap FFE (One per IF Channel)
50 to 90 MHz*
20 dB
0 to -25 dBm in 0.1 dB steps*
-55 dBc in-band
0 to –25 dBm.
10 ppm
± 400 kHz or ± 10% of channel baud rate, whichever is
less
0 to ± 2 Mbits
SNMP
RS-485/-232
Modem Drives External Terminal
2 RU (3.5")
85 to 264 VAC, 50/60 Hz
0 – 50° C
CE mark
-48 VDC
Simplex Configuration, Modulator Only
Simplex Configuration, Demodulator Only
Space Diversity, Demodulator Only
Additional Mod IF Channels. Up to 4 per Chassis
Additional Demodulator IF Channels. Up to 4 per
Chassis
Technical Specifications
7
7-1