Test Menu Options And Parameters - Radyne DMD15 Installation And Operation Manual

DMD15/DMD15L IBS/IDR Satellite Modem
Firmware Rev (menu):
Interface (menu):
UIO Code:
UIO Xilinx:
M&C:
Term Baud:
Emulation:
Remote Addr:
Remote Baud:

4.3.9 Test Menu Options and Parameters

2047 Test:
Insert Errors:
2047 Errors:
2047 BER:
Clear 2047:
TM051 - Rev. 5.8
{Same as remote baud listed below}
Displays the Terminal Port Baud Rate.
{VT100, ADDS-VP, WYSE 50}
Allows the user to select the Terminal Emulation Mode
for the Terminal Port.
{32 - 255}
Allows the user to enter the Remote Port Multidrop
Address.
{150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38,400}
Allows the user to enter the Remote Port Baud Rate.
{None, Tx, Rx, Tx/Rx}
Allows the user to enable or disable the 2047 Pattern
Test. "Tx" enables the transmit pattern generator. "Rx"
enables the receive pattern checker. "Tx/Rx" enables
both.
{0000 - 9999}
Allows the user to select the number of errors to insert.
Once the number of errors to insert has been selected,
pressing 'Enter' twice causes the number of errors
shown to be inserted in the data stream.
{No Sync, nnnn}
Displays the number of errors detected by the 2047
Pattern checker.
-9
{No Sync, nnnn x 10 }
Displays the measured BER for the 2047 Pattern.
{Ent = Y, Clr = N}
Restarts 2047 BER Test.
User Interfaces
4-25