Monitor (Menu) - Radyne MM200 Installation And Operation Manual

MM200 High-Speed Microwave Modem
TERR LOOP
BUFF ENABLE
CLK SOURCE
CLK FREQ
BUFF DEPTH (MS)
PRESS CLR TO
CENTER BUFFER
VOLUME
BYTE GAP
RX INTRFC2
RX INTRFC3
RX INTRFC4

4.4.7 MONITOR (Menu)

The Monitor Screens and their sub-menus are listed below. Those marked with an asterisk (*)
are used for detailed system debug when consulting with Radyne Inc. .
Screen Name
MON MOD (menu)
TM086 - Rev. 4.1
by the installed interface.
{Normal, Loopback}
Not yet implemented, for future
expansion.
{Disable, Enable}
Not yet implemented, for future
expansion.
{RxClk, Ext BNC, Ext Bal, Internal,
TxCLK}
Not yet implemented, for future
expansion.
{2.048 MHz, 5.0 MHz, 10.0 MHz, Data
Rate}
Not yet implemented, for future
expansion.
Not yet implemented, for future
expansion.
Centers the buffer.
Note: Rx Interface between Data and
Volume may need to be masked off
until needed.
{0 - 255}
Allows the user to set volume level
(Orderwire only).
Note: Only appears when supported
by the installed interface.
{0 - 255}
Allows the user to set ASI byte gapping.
Set to 0 for Burst mode. (ASI Interfaces
that support Byte Gap only).
Receive Interface 2. Refer to RX
INTRFC1 (menu) for descriptions.
Receive Interface 3. Refer to RX
INTRFC1 (menu) for descriptions.
Receive Interface 4. Refer to RX
INTRFC1 (menu) for descriptions.
Selections and Descriptions
Monitors the state of the modulator.
User Interfaces
RW RW RW
RW RW RW
RW RW RW
RW RW RW
RW RW RW
RW RW RW
RW RW RW
RW RW RW
L0 L1 L2
4-21