Appendix A - Remote Rllp; Mm200 Opcode Command Set; Modem Command Set - Radyne MM200 Installation And Operation Manual

MM200 High-Speed Microwave Modem
Remote RLLP
When new features are added to Radyne equipment, the control parameters
are appended to the end of the Non-Volatile Section of the Remote
Communications Specification, and status of the features, if any, are added
at the end of the Volatile Section. If a remote M&C queries two pieces of
Radyne equipment with different revision software, they could respond
with two different sized packets. The remote M&C MUST make use of the
non-volatile count value to index to the start of the Volatile Section. If the
remote M&C is not aware of the newly added features to the product, it
should disregard the parameters at the end of the Non-Volatile Section and
index to the start of the Volatile Section.
Before creating any software based on the information contained in this
document, contact the Radyne Customer Service Department
(602-437-9620) to find out if the software revision for that piece of
equipment is current and that no new features have been added since the
release of this document.
A.1 MM200 Opcode Command Set
The MM200 Opcode Command Set is listed below:
A.2 Modem Command Set
Command
Query Identification
Query Control Mode
Query Revision Number
Query Firmware Part Number
Query Time
Query Date
Query Time and Date
Query Current Summary Alarms
Query Latched Summary Alarms
Query Common Configuration
TM086 – Rev. 4.1
Opcode
0x2000
0x2001 Returns current MM200 control mode
0x2002 Returns software revision number
0x2003 Return firmware part number and release date
0x2004
0x2005
0x2006 Returns current time and date
0x2010 Returns current summary alarms
0x2011 Returns latched summary alarms
0x203E Query the MM200 for the common
Appendix A
A
Description
Returns Device ID
Returns current time
Returns current date
A-1