Radyne MM200 Installation And Operation Manual page 163

MM200 High-Speed Microwave Modem
radMM200TxInterfaceLatchedMinorAlarmStatus OBJECT-TYPE
SYNTAX AlarmByteType
MAX-ACCESS
STATUS current
DESCRIPTION
"Minor Alarm status:
Bit 0 = Interface FIFO full
Bit 1 = Interface FIFO empty
Bit 2 = Interface PLL lock
Bit 3 = Interface data activity detect
Bit 4 = Interface clock activity detect
Bit 5 = Interface Tx input framing valid, added for AASI
Bit 6 = Interface signal loss, valid for some interfaces
Bit 7 = Spares
0 = Pass, 1 = Fail"
::= { radMM200TxInterfaceStatusEntry 5 }
radMM200TxInterfaceCard OBJECT-TYPE
SYNTAX INTEGER {
}
MAX-ACCESS
STATUS current
DESCRIPTION
::= { radMM200TxInterfaceStatusEntry 6 }
-- --------------------------------------------------------------------------------------------------------------------
-- --------------------------------------------------------------------------------------------------------------------
-- MM200 demodulator non-volatile status information.
radMM200RxIFFrequency OBJECT-TYPE
SYNTAX INTEGER (50000000..90000000)
MAX-ACCESS
STATUS current
DESCRIPTION
"Selects IF frequency in Hz. This is the center
frequency of the aggregate; the edge frequency,
however, is dependent on the number of channels,
symbol rate, and spacing. The frequency range
of the MM200 is 50MHz to 90MHz."
::= { radMM200DemodNVStatus 1 }
radMM200RxIFUser1Frequency OBJECT-TYPE
SYNTAX INTEGER (50000000..90000000)
MAX-ACCESS
STATUS current
DESCRIPTION
"Selects IF user 1 frequency in Hz."
::= { radMM200DemodNVStatus 2 }
radMM200RxIFUser2Frequency OBJECT-TYPE
SYNTAX INTEGER (50000000..90000000)
MAX-ACCESS
STATUS current
DESCRIPTION
"Selects IF user 2 frequency in Hz."
::= { radMM200DemodNVStatus 3 }
TM086 – Rev 4.1
read-only
none(1),
asi_aasi(2),
nasi(3),
t3e3(4),
t1e1(5),
ds0(6),
parallel(7),
oc3(8),
hssi(9),
smpte(10)
read-only
"Interface card type."
read-write
read-write
read-write
Appendix B
B-15