Radyne MM200 Installation And Operation Manual page 46

User Interfaces
TX ENABLED
INSTALLED CHs
MON DMD (menu):
DMD SNR X 10
DMD AGC
LEVEL (dBm)
LEVEL 1&2 (dBm)
LEVEL 3&4 (dBm)
PRE FEC1 BER
POST FEC1 BER
PRE FEC2 BER
POST FEC2 BER
PRE FEC3 BER
POST FEC3 BER
PRE FEC4 BER
POST FEC4 BER
DMD1 STATE
DMD2 STATE
DMD3 STATE
DMD4 STATE
4-22
OFF, ON}
Displays TX Power Control Status
{0 – 4}
Displays number of installed channels
Monitors the state of the demodulator.
{000 – 999 000 – 999 000 – 999 000 -
999}
Displays the demodulator signal-to-noise
ratio for each channel. Divide each
number by 10 to get the dB value (i.e. 355
= 35.5 dB).
{000 – 655 000 – 655 000 – 655 000 -
655}
Displays a relative indication of the AGC
level of each channel. Optimum
performance is approximately 320 – 420.
The lower the number, the higher the IF
signal.
Monitors the aggregate input level in dBm.
Monitor channels 1 and 2 input levels in
dBm.
Monitor channels 3 and 4 input levels in
dBm.
Displays channel 1 pre FEC BER.
Displays channel 1 post FEC BER.
Displays channel 2 pre FEC BER.
Displays channel 2 post FEC BER.
Displays channel 3 pre FEC BER.
Displays channel 3 post FEC BER.
Displays channel 4 pre FEC BER.
Displays channel 4 post FEC BER.
{Locked, Unlocked}
{Locked, Unlocked}
{Locked, Unlocked}
{Locked, Unlocked}
MM200 High-Speed Microwave Modem
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
TM086 - Rev. 4.1
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO
RO RO