Table of Contents
Advertisement
User Interfaces
PRESS CLR TO
CENTER BUFFER
VOLUME
BYTE GAP
RX INTRFC2
RX INTRFC3
RX INTRFC4
4.4 All Level Menu Screens
4.4.1 Main Menu Screens
Main Menu Screens (one of which is a Title Screen) are listed below:
MM-200 MODULATOR
MODULATOR (menu):
DEMODULATOR (menu):
REPEATER (menu):
APC (menu):
TX INTERFACE (menu):
RX INTERFACE (menu):
MONITOR (menu):
ALARMS (menu):
SYSTEM (menu):
TEST (menu):
4.4.2 MODULATOR (menu) *
The Modulator Menu Screens are listed below:
Screen Name
FREQUENCY (Hz)
4-12
Centers the buffer.
{0 - 255}
Allows the user to set volume level
(Orderwire only).
Note: Only appears when supported
by the installed interface.
{0 - 255}
Allows the user to set ASI byte gapping.
Set to 0 for Burst mode. (ASI Interfaces
that support Byte Gap only).
Receive Interface 2. Refer to RX
INTRFC1 (menu) for descriptions.
Receive Interface 3. Refer to RX
INTRFC1 (menu) for descriptions.
Receive Interface 4. Refer to RX
INTRFC1 (menu) for descriptions.
Title Screen:
Not a modifiable screen.
Selections and Descriptions
{50 – 90 MHz}
Controls the current center band of the
MM200 High-Speed Microwave Modem
RW
RW
RW
L0
RW
TM086 - Rev. 4.1
L1
L2
RW
RW
Advertisement
Table of Contents
Troubleshooting
