Radyne MM200 Installation And Operation Manual page 102

Appendix A
Query Mod Tx Enable
Query Mod Tx Carrier
Query Mod Channel Status
Query Mod Channel Configuration
Query Mod Channel Config & Status
Query Mod Status
Query Mod Configuration
Query Mod Configuration & Status
Query Demod Diversity Status
Query Demod Channel Status
Query Demod Channel Configuration
Query Demod Channel Config &
Status
Query Demod Status
Query Demod Configuration
Query Demod Configuration & Status
Query Tx Interface Status
Query Tx Interface Configuration
Query Tx Interface Config & Status
Query Tx Interface Jitter Control
Query Rx Interface Status
Query Rx Interface Configuration
Query Rx Interface Config & Status
Query Rx Interface Jitter Control
Query Rx Interface Byte Gapping
Command Control Mode
Command Time
Command Date
Command Time and Date
Command Clear Latched Alarms
Command Common Alarm Mask
Command Last Rate Control
Command Frequency Plan
Command User Mode
Command Mux Loopback
A-2
MM200 High-Speed Microwave Modem
0x2054 Returns the carrier enable status
0x2055 Returns the carrier mode
0x2070 Query selected modulator channel status
0x2071 Query selected modulator channel
0x2072 Query selected mod channel config and status
0x207D Query modulator status
0x207E Query modulator configuration
0x207F Query modulator configuration and status
0x2098 Query demodulator diversity status
0x20B0 Query selected demodulator channel status
0x20B1 Query selected demod channel configuration
0x20B2 Query selected demod channel config and
0x20BD Query demodulator status
0x20BE Query demodulator configuration
0x20BF Query demodulator configuration and status
0x2140 Query selected Tx interface status
0x2141 Query selected Tx interface configuration
0x2142 Query selected Tx interface config and status
0x2143 Query selected Tx interface jitter control
0x2160 Query selected Rx interface status
0x2161 Query selected Rx interface configuration
0x2162 Query selected Rx interface config and status
0x2163 Query selected Rx interface jitter control
0x2164 Query selected Rx interface byte gap
0x2201
0x2204
0x2205
0x2206
0x2207
0x2208 Set common alarm mask
0x2209
0x220A
0x220B
0x220C Selects the multiplexer loopback mode
configuration
configuration
status
Set control mode
Set time
Set date
Set time and date
Clear latched alarms
Set last rate control
Set IF frequency plan
Selects the user mode
TM086 – Rev. 4.1