Radyne MM200 Installation And Operation Manual page 139

MM200 High-Speed Microwave Modem
Opcode: <0x2255>
<1> Carrier Mode
Opcode: <0x2258>
<1> IF Separation
Opcode: <0x2259>
<1> Channel Setting
Opcode: <0x225A>
<4> Frequency 1
<4> Frequency 2
<4> Frequency 3
<4> Frequency 4
Opcode: <0x225B>
<4> Bandwidth
Opcode: <0x2270>
<1> Selected channel
number
<1> Channel Major
Alarm Mask
TM086 – Rev. 4.1
Command modulator carrier mode
Command Data
0 = normal
1 = CW
2 = offset 1Hz
3 = 100KHz
4 = 3.5MHz
5 = sweep up
6 = sweep down
Command modulator IF separation
Command Data
100 - 150%
Command modulator channel setting
Command Data
0 = auto
1 = one
2 = two
3 = three
4 = four
5 = debug
Command modulator user frequencies
Command Data
50 MHz – 90 MHz
50 MHz – 90 MHz
50 MHz – 90 MHz
50 MHz – 90 MHz
Command modulator bandwidth
Command Data
Available bandwidth
Note: Command is only allowed in Level 2 User Mode.
Along with the selected interfaces, and the number of
channels, the modem calculates all relevant system
parameters optimizing for robustness (minimizing
modulation).
Command selected modulator channel configuration
Command Data
0 = channel1
1 = channel2
2 = channel3
3 = channel4
0 = Mask, 1 = Allow
Bit 0 = Mod daughter board FPGA status
Bit 1 = RF PLL lock detect status
Appendix A
A-39