Radyne MM200 Installation And Operation Manual page 134

Appendix A
<1>
Interface Sub
Type
<1>
Interface Clock
Source
<1>
Interface Clock
Frequency
<1>
Interface
Framing
<1>
Interface Volume
<1>
Interface Clock
Polarity
<1>
Interface Data
Polarity
<1>
Reserved
<1>
Interface
<1>
Terrestrial Loopback
Interface PRBS
<1>
Interface Major
Alarm1 Mask
<1>
Interface Minor
Alarm1 Mask
<1> Interface Major
Alarm1Status
<1> Interface Minor
Alarm1 Status
A-34
20 = DS0 APC
Reserved, selects the Rx interface sub-type
0 = Rx Clk
1 = Ext BNC
2 = Ext Bal
3 = Internal Clk
0 = 2.048 MHz
1 = 5.0 MHz
2 = 10.0 MHz
3 = Data Rate
0 = unframed
1 = MPEG 188
2 = MPEG 204
3 = Null 188
4 = Null 204
0 – 255
0 = normal, 1 = inverted, 2 = no auto
0 = normal, 1 = inverted
Spare
0 = disable, 1 = enable
0 = normal
1 = prbs_23
2 = prbs_23m
3 = prbs_15
4 = prbs_15m
(Not Yet Implemented)
0 = Mask, 1 = Allow
Bit 0 = Interface Test
Bit 1 - 7 = Spare
0 = Mask, 1 = Allow
Bit 0 = Interface FIFO full
Bit 1 = Interface FIFO empty
Bit 2 = PLL lock
Bit 3 = Interface data activity detect
Bit 4 = Interface clock activity detect
Bits 5 - 7 = Spare
Status Bytes
0 = Pass, 1 = Fail
Bit 0 = Interface Test
Bit 1 - 7 = Spare
0 = Pass, 1 = Fail
Bit 0 = Interface FIFO full
MM200 High-Speed Microwave Modem
TM086 – Rev. 4.1