Test Menu Options And Parameters - Radyne DMD20 Installation And Operation Manual

DMD20 Universal Satellite Modem
HW/FW CONFIG (menu)
FIRMWARE REV
MAIN BOARD (menu)
Note: Only the appropriate of the VCO adjustment screens listed below will be
displayed. These are protected fields, to prohibit accidental changes. To edit the
field, the user must depress all four of the direction arrow keys simultaneously.
INT VCO ADJUST
HI STAB VCO ADJUST
TERR INTFC BOARD (menu) Relevant interface revision information. May be blank.
FEATURES (menu)
TBD

4.3.9 Test Menu Options and Parameters

TX TEST PATTERN
RX TEST PATTERN
PATTERN SYNC
TST PAT ERR CNT
TST PATT BER
RESTART TST PAT ((ENTER))
TM103 – Rev. 1.1
Displays the installed firmware revision.
{0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed of the system
reference clock is INTERNAL.
{0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
{NONE, 2047, 2^15-1, 2^23-1}
Allows the user to enable the tests listed above.
{NONE, 2047, 2^15-1, 2^23-1}
Allows the user to enable the tests listed above.
{YES, NO}
Yes indicates that the RX Test Pattern is in sync.
n
{NO SYNC, nnnn x 10
Displays the number of errors detected by the test
pattern checker.
-n
{NO SYNC, nnnn x 10
Displays the measured BER for the test pattern.
Press ENTER to restart the test.
User Interfaces
}
}
4-25