Global Response Operational Codes - Radyne MM200 Installation And Operation Manual

User Interfaces

4.5.4 Global Response Operational Codes

In acknowledgment response packets, the operational code <OPCODE> field of the message
packet is set to 0 by the receiving devices when the message intended for the device is evaluated
as valid. The device that receives the valid message then exchanges the <SOURCE ID> with the
<DESTINATION ID>, sets the <OPCODE> to zero in order to indicate that a good message was
received, and returns the packet to the originator. This "GOOD MESSAGE" Opcode is one of
nine global responses. Global response Opcodes are common responses, issued to the M&C
computer or to another device, that can originate from and are interpreted by all Radyne Inc.
equipment in the same manner. These are summarized as follows all Opcode values are
expressed in decimal form:
RESPONSE OPCODE DESCRIPTION
Command Not Allowed in LOCAL Mode
Command Not Allowed in AUTO Mode
Unable to Process Command
The following response error codes are specific to the MM200:
MM200 Response Error Code Descriptions
REMOTE_SIZE_ERROR
REMOTE_UNKNOWN_ERROR
REMOTE_CONTROL_ERROR
REMOTE_PARAMETER_ERROR
REMOTE_LASTRATE_ERROR
REMOTE_SYMBOL_LO_ERROR
REMOTE_SYMBOL_HI_ERROR
REMOTE_DATA_LO_ERROR
REMOTE_DATA_HI_ERROR
REMOTE_FRAMING_ERROR
REMOTE_MODULATION_ERROR
REMOTE_DEMODULATION_ERROR
REMOTE_CHANNEL_ERROR
4-34
Table 4-5. Response OPCODES
Good Message
Bad Parameter
Bad Opcode
Bad Checksum
Bad Destination
Packet Too Long
REMOTE_GOOD
MM200 High-Speed Microwave Modem
OPCODE
000d = 0x0000
255d = 0x00FF
254d = 0x00FE
253d = 0x00FD
252d = 0x00FC
251d = 0x00FB
250d = 0x00FA
249d = 0x00F9
248d = 0x00F8
OPCODE
0x0000
0x0201
0x0202
0x0203
0x0204
0x0205
0x0206
0x0207
0x0208
0x0209
0x020A
0x020B
0x020C
0x0210
TM086 - Rev. 4.1