Radyne MM200 Installation And Operation Manual page 65

MM200 High-Speed Microwave Modem
1. Verify that your emulation software is set to the following:
VT100
9600 baud
8 data bits
no parity
1 stop bit
Modify the MM200 selection, if necessary, to match the settings (the Front Panel
'SYSTEM' Sub-Menu contains all the Terminal Emulation Controls).
2 If the system is set up properly and the terminal fails to come up, verify that the Terminal
Cable (CA/3448-6) is attached properly from the Back Plate (J2) to the Header (J9) on the
Main M&C Card (AS/4458).
3. Switch S3 settings should be set as follows:
SW1:
SW2:
SW3:
SW4:
TM086 - Rev. 4.1
Figure 1.
On
On
Off
Off
User Interfaces
4-41