Manual (for paper of which the leading edge rubs the printhead)
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Paper tab (
• If the Tab Selection screen is not displayed, press the Menu button.
Press the OK button. The Paper Menu is displayed.
Press ▲ or ▼ to select Paper Details, and then press the OK button.
Press ▲ or ▼ to select the type of paper, and then press the OK button.
Press ▲ or ▼ to select Cutting Mode, and then press the OK button.
Press ▲ or ▼ to select Manual, and then press the OK button.
When Perform the detection of paper leading edge? is displayed, select Do not perform.
• If you set the detection of paper leading edge to Do not perform, a margin of about 10 cm is created
at the paper leading edge when printing starts.
• When the detection of paper leading edge is set to Do not perform, printing will start at the position
at which the roll was set for the first printing after replacing a roll. Thus, the margin of the paper
leading edge will enlarge.
(See "Loading Rolls in the Printer.")
Specifying the Cutting Method for Rolls