There is some foreign object near the Media Take-up Unit sensor
and the roll cannot be detected.
The Media Take-up Unit sensor is soiled and the roll cannot be de-
The roll is out of range of detection by the Media Take-up Unit sen-
A paper jam has occurred and the roll cannot be rewound.
The Media Take-up Unit sensor is damaged.
*1: Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to
stop, set Skip Take-Up Err to On. However, note that this error may cause paper jams and affect the printing
Media take-up unit ready.
The Take-up Reel setting in the printer Set./Adj.
Menu was changed from Enable to Disable, but a
print job was received before the roll was re-
Turn on the media take-up unit.
The Media Take-up Unit was off when you selected Enable for Take-up Reel.
Borderless printng not possible.
The print job received specifies a
type or width of paper that is not
compatible with borderless print-
Press ▲ or ▼ to select Stop Printing, and then press the OK
button to stop printing.
The mode switches from take-up mode to regular mode after you
change the Take-up Reel setting in the Set./Adj. Menu from En-
able to Disable and lift the Release Lever to remove a roll, or af-
ter you execute Paper Cutting.
Press ▲ or ▼ to select Print, and then press the OK button to
Follow these steps to change the settings of the print job to enable borderless print-
1. Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2. Make sure the correct printer driver for the printer is selected and try printing
For information on types of paper compatible with borderless printing, refer to
the Paper Reference Guide.
(See Paper Reference Guide .)
Messages regarding paper
Remove the foreign object near the sensor.
Wipe the sensor with a dry cloth to clean it.
Reload the roll.
(See "Loading Rolls in the Printer.")
Remove the paper from the Media Take-up Unit.
Press the OK button to clear the error.
Contact your Canon dealer for assistance.
Turn the Media Take-up Unit on.