(The type of pa-
per is displayed
Adjust the Printhead height. (See "Troubleshooting Paper
Abrasion and Blurry Images (Head Height).")
If you print on Japanese paper (washi) or other handmade pa-
per that has an irregular width, choose Loose for a higher
skew detection threshold, or choose Off to disable skew de-
tection. However, if paper is loaded askew when detection is
Off, note that paper jams or Platen soiling may occur.
Specify whether or not to cut with the standard round-bladed
If you choose Automatic, the roll will be cut automatically
using the Cutter Unit, depending on the printer driver set-
Select Eject to prevent printed documents from falling imme-
diately after printing such as when you wait for the ink to dry,
etc. Manual prints lines at the cut position instead of cutting
after printing. If you select Manual, the setting screen for de-
tection of the paper leading edge is displayed.
(See "Specifying the Cutting Method for Rolls.")
Choose the cutting speed. The preset selection represents the
optimal cutting speed for the type of paper. We recommend
keeping the preset cutting speed.
If you use adhesive paper, choosing Slow helps prevent adhe-
sive from sticking to the cutter and keeps the cutter sharp.
If a roll is loaded, the end of the paper will be cut.
If you choose On, a line will be printed at the cut position
when paper cutting is selected. This option reduces the
amount of debris given off after cutting. It also helps prevent
adhesive from sticking to the cutter and keeps the cutter sharp
if you use adhesive paper. (See "Reducing Dust from Cut-
Specify the level of suction that holds paper against the Plat-
en. (See "Adjusting the Vacuum Strength (Vac-
Select Entire area to apply the ink drying time after each
scan until the document is fully printed.
If you select Leading edge, the drying time is entered per
each scan until about 130–160 mm (5.1–6.2 in) from the lead-
ing edge of the paper, and colors may be uneven in the boun-
dary between the areas with and without a drying time. (The
applicable length varies depending on the Print Quality set-
Specify the time to wait for the ink to dry for each sheet.
Specify the minimum margin at the leading edge of roll paper
to ensure better printing quality at the leading edge.
Note that if you choose 5mm, it may lower the printing quali-
ty at the leading edge and affect feeding accuracy. The prin-
ted surface may be scratched, and ink may adhere to the lead-
ing edge. It may also cause the Platen to become soiled.