The Edges Of The Paper Are Dirty - Canon iPF8300S User Manual

Hide thumbs Also See for iPF8300S:
Table of Contents

Advertisement

Cause
Since the leading edge of the pa-
per strongly warps upward or rip-
ples, the leading edge of the pa-
per rubs against the printhead.

The edges of the paper are dirty

Cause
The Platen has become dirty after
borderless printing or printing on
small paper.
The type of paper as specified on
the printer does not match the type
specified in the printer driver.
The paper is wrinkled or warped.
A cut line is printed because Cut-
DustReduct. is On in the Control
Panel menu to reduce cutting dust.
The Printhead is set too low in the
Control Panel menu.
You are printing on heavyweight
paper or paper that curls or wrinkles
easily after absorbing ink.
The Ejection Guide is soiled.
iPF8300S
Troubleshooting
Set Cutting Mode to Manual on the Control Panel menu, and select Off for the
paper leading edge detection setting.
In this case, when keeping track of the amount of roll paper left, set ManageRe-
mainRoll to Off before loading the roll paper and then set ManageRemainRoll to
On after loading the roll paper.
(See "Specifying the Cutting Method for Rolls.")
(See "Keeping Track of the Amount of Roll Paper Left.")
Open the Top Cover and clean the Platen.
(See "Cleaning Inside the Top Cover.")
Make sure the same type of paper is specified on the printer as in the printer
driver.
(See "Changing the Type of Paper.")
Make sure the same paper type is specified in the printer driver as on the printer.
1. Press the Stop button and stop printing.
2. Change the type of paper in the printer driver and try printing again.
Straighten out the wrinkles or curls and reload the paper. Do not use paper that
has been printed on previously.
(See "Loading Rolls in the Printer.")
(See "Loading Sheets in the Printer.")
If this function is not needed, set CutDustReduct. to Off in the Control Panel
menu.
(See "Menu Settings.")
→P.938
In the Control Panel menu, set Head Height to Automatic.
(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")
→P.854
When printing on Heavyweight Coated Paper or other paper-based media,
choose a VacuumStrngth setting of Strong or Strongest in the Control Panel
menu. If rubbing still occurs, in the Control Panel menu, use a higher Head
Height setting.
(See "Adjusting the Vacuum Strength (VacuumStrngth).")
(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")
→P.854
When printing on CAD Tracing Paper or other film-based media, choose a Vac-
uumStrngth setting of Standard, Strong, or Strongest in the Control Panel
menu. If rubbing still occurs, in the Control Panel menu, use a higher Head
Height setting.
(See "Adjusting the Vacuum Strength (VacuumStrngth).")
(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")
→P.854
Clean the Ejection Guide.
(See "Cleaning the Printer Exterior.")
>
Problems with the printing quality
Corrective Action
→P.802
→P.799
Corrective Action
→P.1040
→P.791
→P.786
→P.813
→P.1039
The edges of the paper are dirty
>
12
→P.863
1073
→P.863

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iPF8300S and is the answer not in the manual?

Table of Contents