Repl. maint cart
Repl. S. Cleaner
"Set Exec. Guide"
If you select On, a message is displayed on the con-
trol panel at the timing recommended for executing
Clear the color calibration adjustment value and the
Clean the Printhead. (See "Cleaning the Printhead.")
Choose Head Cleaning A if printing is faint, oddly
colored, or contains foreign substances.
Choose Head Cleaning B if no ink is printed at all, or
if printing is not improved by Head Cleaning A.
Print a test pattern to check the nozzles.
Execute when replacing the Printhead. Follow the in-
structions displayed to complete the required proce-
dure. (See "Replacing the Printhead.")
Not displayed during a warning message that the re-
maining Maintenance Cartridge capacity is low.
Execute when replacing the Maintenance Cartridge.
Follow the instructions displayed to complete the re-
quired procedure. (See "Replacing the Maintenance
Indicates information about the printhead.
Replace the Shaft Cleaner. Follow the instructions
displayed to complete the required procedure. (See
"Replacing the Maintenance Cartridge.")
Replace the Cutter Unit. Follow the instructions dis-
played to complete the required procedure. (See "Re-
placing the Cutter Unit.")
Once you replace the Cutter Unit, you can also reset
the cut counter.
Specify the timeout period before cancellation of print
jobs that cannot be received by the printer.
Choose whether the printer IP address is configured
automatically or a static IP address is entered manual-
Specify the protocol used to configure the IP address
Specify the printer network information when using a
static IP address.
Enter the IP address assigned to the printer, as well as
the network subnet mask and default gateway.
The value that was automatically configured is dis-
played if you have set IPv4 Mode to Automatic.