Cannot Cut This Paper; End Of Paper Feed; Rel Lever Is In Wrong Position - Canon iPF8300S User Manual

Error Message >

Cannot cut this paper.

There are sheets left on the
Ejection Guide.
There is a foreign object by
the Output Tray, obstruct-
ing the Cutter Unit.
You are not using the print-
er under the recommended
environmental conditions
for the paper.
You are using paper that is
not compatible with auto-
matic cutting.
In other cases, the Cutter
Unit may be damaged.

End of paper feed.

13
You are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge.
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit.

Rel lever is in wrong position.

1104
Cause
The Release Lever is up.
Cannot cut this paper.
Messages regarding paper >
Cause
1. Lift the Release Lever and remove the paper.
2. Load paper.
3. Lower the Release Lever.
4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Dis-
play Screen, press the OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.")
1. Lift the Top Cover and remove the foreign object.
2. If "Not finished printing. Finish printing remaining jobs?" is shown on the Dis-
play Screen, press the OK button.
Printing will resume, starting from the page on which the error occurred.
Use the printer only where the recommended environmental conditions for the paper are
met. Note that various environmental conditions are recommended for various types of
paper. For details on the recommended environmental conditions, see the Paper Refer-
ence Guide.
(See Paper Reference Guide .)
1. Specify Manual as the cutting method and use scissors or a cutting tool to cut the
roll.
(See "Specifying the Cutting Method for Rolls.")
For information about paper that is compatible with automatic cutting, see the Paper
Reference Guide.
(See Paper Reference Guide .)
2. Lift the Release Lever and remove the paper.
Contact your Canon dealer for assistance.
Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Corrective Action
→P.786
Cause
Corrective Action
→P.802
Corrective Action
Release the ▲ button.
Release the ▲ button.
iPF8300S