Device Settings And Operation - Fujitsu IP-900E Hardware User's Manual

3.2
3.2
■Setup Procedure
The setup procedure is shown below.
See Software User's Guide for the procedure of the software installation and the each setting.
Connect IP-900 and PC
using UTP cable
Turn ON IP-900
Change network settings
(Refer the software user's guide)
Connect user's network
Start settings and operations
(Refer the software user's guide)
■Web browser recommended
The recommended web browser is as follow.
- Internet Explorer 6.0 SP2 or later

Device Settings and Operation

- Check if IP-900 is disconnected to user's network.
- Connect using UTP cable.
- When connect through LAN port, the default IP address and subnet
mask are 10.0.0.1 and 255.0.0.0 respectively. Assign 10.xxx.xxx.xxx for
PC.
(ex. IP address: 10.0.0.2, Subnet mask: 255.0.0.0)
for PC.
For details, please refer to the Software User's Guide.
- Execute the Network setting from WEB GUI after the device starts.
For details, please refer to the Software User's Guide.
47
Chapter 3 Operation Instructions
IP-900E/IP-900D/IP-900IID