Table of Contents
Advertisement
-
Enter the ISP's IP Address in the "Name Server" location if your ISP has provided this
information. (This is the DNS address provided by your ISP.)
-
Close the window.
4. Click "Save" from the file menu then "Quit" TCP/IP.
5. Restart the computer.
6-3 NetComm Cable/DSL Firewall Router Configuration
To configure your NetComm Cable/DSL Firewall Router, launch your Web Browser and follow
the instructions given in Chapter 3: Internet Access, section 3.3. To configure advanced settings,
refer to Chapter 4: Advanced Configuration.
6-4 Adding NetComm Cable/DSL Firewall Router to Existing
Network
If the NetComm Cable/DSL Firewall Router is to be added to an existing Macintosh computer
network, the computers will have to be configured to connect to the Internet via the NetComm
Cable/DSL Firewall Router.
1. From the "Apple" menu, select "Control Panel" and click on "TCP/IP".
2. From the "File" menu, select "Configurations" and select your existing network
configuration. Click "Duplicate".
3. Rename your existing configuration. Click "OK", and "Make Active".
4. In the Setup area:
-
Select "Manually" in the "Configure" location from the drop-down list.
-
In the "IP Address" location, enter the IP Address that you want to assign to the
computer (for example 192.168.1.2) .
-
Enter "255.255.255.0" in the "Subnet Mask" location.
-
Enter "192.168.1.1" (the NetComm Cable/DSL Firewall Router's default IP Address) in
the "Router Address" location.
-
Enter the ISP's IP Address in the "Name Server" location if your ISP has provided the
information.
-
Close the window.
5. Click "Confirm". TCP/IP is now configured for manual IP Addressing.
6. Configure your NetComm Cable/DSL Firewall Router (see 6.3 above).
www.netcomm.com.au
Page 50
Rev.2 - YML630
Cable/DSL Firewall Router
Advertisement
Table of Contents
