Pad Configuration Commands; Idnt Pad Identification String; Icto Inter-Character Timer; To Suit Software Version - NetComm NTC-6000 Series Command Manual

Cellular

Hide thumbs Also See for NTC-6000 Series:

Table of Contents

PAD Configuration commands

^IDNT

PAD identification string

This command is used to configure an identification string to be sent at the

beginning of each PAD session.

This string will be sent followed by a terminating <LF> either as the first UDP

datagram or the first bytes of a TCP stream.

If this parameter is not set (empty) no identification data is sent, nor is the

terminating <LF>

Default:

<empty>

Command values:

^IDNT=<ID>

^ICTO

Inter-character timer

This command is used to configure the Inter-Character timeout used by the PAD

service when assembling packets for transmission.

The PAD will send a packet of data every time the buffer is full (512 Bytes) or if the

serial data line is idle for longer than the time specified by this command.

Default:

Command values:

^PADM=<timeout> Where <timeout> is a number between 0 and 65535

NTC-6000 Series V.250 Manual

Storage:

Where <ID> is a string with maximum length of 32 bytes.

Storage:

milliseconds.

Page 22 of 32

7/21/2010

Table of Contents