Use The Media Counter - Oce CS 5090 User Manual

When you use this setting, keep in mind the following principles:
This setting does not work with cut sheets as the selected media
I
This setting is a machine setting and therefore activates each time you switch
I
on the printer, until you manually turn it off from the control panel menu
You cannot store this setting as a user setting
I
You cannot change this setting once printing begins
I
When you manually press "Pause" to resume printing, the "Feeder stop"
I
detection disables for the remainder of the print
When activated, the "Feeder stop" detection restarts at the beginning of each
I
print.
M M M M
To set the "Feeder stop"
Press 'Feed Media/End of Media'.
1
Choose 'Feeder Stop'.
2
Press 'OK'.
3

Use the media counter

The media counter gives you a means of "estimating" the length of media left
on a roll.
When you install a new roll (or used roll of media with a known length), you
I
enter the length in the media counter on the control panel.
As the printer uses up the media, this value decreases and displays on the
I
control panel.
When you remove the media roll, you can print the estimated remaining
I
length on the roll, and enter this value in the media counter the next time you
use this roll.
M M M M
To enter a media length value
Press 'Feed Media/Media counter'.
1
Enter the media length.
2
Press 'OK'.
3
M M M M
To display the media length value
Press 'Feed Media'.
1
Then, select 'Display counter'. The current value appears.
2
Handling ink and media 79