Set The 'Control' Function - Oce CS 5090 User Manual

Set the 'Control' function

You set control to establish whether it is the software application or the printer
control panel that determine certain printing functions. Control overrides the
following functions in the HP-GL/2 header file:
'Repeat Plot' (RP): when you set control to the printer, the printer will ignore
I
RP commands in the print file and output only one print. On the control
panel, you can use the 'HP-GL/2/Reprints' menu to specify additional
copies.
'Enable Auto Cutter' (EC): when you set control to the printer, the printer
I
will ignore EC commands in the print file, and does not cut automatically
after each print. On the control panel, you can enable automatic cutting or
initiate a command for a single cut.
Do not override software control when sending merged raster/vector
Note:
data to the printer.
M
To set control
From the main menu, press
1
Choose either
2
Press
3 OK
62 Océ CS 5090 User Manual
Setup menu
or
Software Printer
.
/
HP-GL/2 menu/Control
.
.