Run A Colour Test - Oce CS 5090 User Manual

Run a colour test

An initial colour test checks for correct cartridge priming, to ensure that all
colours print in a uniform and solid pattern.
M M M M
To print the colour test
Check that the printer has media loaded.
1
Press
2 Setup menu/Print Mode menu
Press
3 Print passes
Change to 2-pass mode using the Next or Prev option buttons.
4
Select
5 Utility menu/Service menu/Diagnostics menu/Colour Test menu.
At this stage, you can choose between two different options:
Print a colour test for each colour separately, one after the other.
I
Print a colour test for all colours at the same time (only supported by
I
firmware version 1.13 or above).
M M M M
To print the test (colours one by one)
Press
1 Stall select
option buttons.
Press
2 Density select
Press
3 Colour test print
disregard the quality of the colour patterns.
Ensure each print passes completes.
4
M M M M
To print the test (all colours at the same time
The all colour test is only supported by firmware version 1.13 or above.
Note:
Press
1 Density select
Press
2 All Colour test
No ink starvation should be observed. If you notice ink starvation,
Note:
re-prime the cartridge and check the ink level.
Getting started
.
.
to select the appropriate colour to test using the Next or Prev
to set the *colour test percentage to 100%.
. Several print passes will initiate in the chosen colour,
to set the colour test percentage to 100%.
to initiate the test.
35