Oce CS 5090 User Manual page 82

Four different modes are available:
'Off': when this mode is selected, the dryer firmware is active (it monitors
I
the ambient temperature and humidity) but does not take into account any
printing operation. In this case, the dryer is not activated.
'On': when this mode is selected, it applies maximum dryer output
I
temperature for every print job, whatever the ambient temperature and
humidity is.
'Auto': when this mode is selected, the dryer firmware monitors the ambient
I
temperature and humidity and calculates the best drying time to apply for
each print job. It can also increase the output temperature whenever the print
job requires it (for e.g., when a chosen print mode results in an increasing
print speed, the increase is automatically detected by the firmware which
adjusts the drying time consequently).
'Fans only': when this mode is selected, the dryer is working but without the
I
heaters switched on. It is blowing only cold air. It is advised to select this
mode when using specific media that do not support heating. Blowing cold
air prevents the media from curling and deforming.
For more details about the media, please refer to the Media Product
Note:
Information Sheets on www.oce.com.
Caution:
connected. Always unplug the dryer power cable before connecting the
data cable. When connecting or disconnecting dryer power cord or dryer
data cable, the printer power switch MUST be in the Off position. Failure
to follow these instructions may damage the printer.
Attention:
Caution:
dryer, even when the printer is turned off.
M M M M
Select the dryer mode
Select 'Setup menu/Ink option menu/Dryer'.
1
Choose the dryer mode (Off/On/Auto/Fans only) by pressing 'Next option' or
2
'Previous option'.
Press 'OK'.
3
When the dryer is activated, drying continues even after the print is
Note:
finished, and as a consequence, the printer cannot be accessed until drying is
finished.
82 Océ CS 5090 User Manual
Never connect the dryer data cable when the dryer power cable is
Never open the dryer. There are no user serviceable parts inside.
Once the dryer is plugged in, there is continuous power to the