Oce CS 5090 User Manual page 31

M
To prime the delivery lines
Fill ink reservoirs (see 'To fill the ink reservoirs' on page 26). Do not exceed
1
maximum level line.
Attach reservoir to appropriate ink delivery line by depressing quick connect
2
tab and snapping reservoir into place.
[13] Quick connect fitting
For right order to place the ink reservoirs, see sticker on carriage.
Note:
Close the ink delivery lines by pushing the valve up on the carriage:
3
Insert the needle assembly connector into the fitting on the carriage. On the left
4
set of cartridges, there are two connectors for each cartridge (one blue and one
gray). Be sure the needle assembly is plugged into the same colour connector
as in the ink reservoir.
Obtain the Océ CS 5090 Prime tool.
5
Open the ink delivery lines by pushing the valve down.
6
Prime each tubing/chain ink line by inserting the cartridge needle into the end
7
of the Prime tool and press the button several times until a solid stream of ink
is present throughout tubing.
Getting started 31