Oce CS 5090 User Manual page 133

Colours are not correct or sections of print missing
Prime, clean, calibrate, or replace cartridges.
I
Image is the wrong size
Check that the dpi setting (300 or 600) matches the size of your image file.
I
Print only contains a partial image
Check the settings of the margins option. When you set margins to Normal
I
(default), the print area is smaller than with the margins set to Expanded.
The printer did not size correctly the media. Use the Manual load option to
I
load your media.
The printer automatically prints in portrait orientation. If you rotated the
I
image in the software to save to save paper, set the paper size to the next
larger size (i.e. for a C size image, select D size paper). Set the Save media
option to ON to stop the printer from scrolling the full paper height.
Jagged vertical lines
Prime, clean, calibrate, or replace cartridges.
I
Splotchy area fill
Try using photo mode. If the problem persists, prime, clean, calibrate, or
I
replace cartridges.
Excessive banding in area fills
Consistent banding generally indicates a hardware problem; whereas
I
inconsistent banding indicates a software problem.
Use specially coated inkjet media.
I
Change the Print Mode option to User-defined and select a higher number of
I
print passes (see 'Set print passes' on page 96).
Prime, clean, calibrate, or replace cartridges.
I
Set wiper function to off.
I
Error handling and troubleshooting 133