Oce CS 5090 User Manual page 137

Testing your E-connect
The E-connect print server will go through the following startup sequence:
It will run through a set of power-up diagnostics for a few seconds. If the print
1
server is operating properly, the TEST LED will blink momentarily and then
go out. If the TEST LED blinks continuously in a regular pattern, there is a
problem. If this is the case, first verify that you have a good Ethernet
connection and then try powering the unit off and then on again. If the problem
persists, refer to the Troubleshooting chapter in the administrator guide.
When the test LED goes out, the other LEDs on the print server will come on
2
as follows:
On the E-connect the Link OK LED will blink if the print server detects
I
activity on the network. The 100baseTX LED will come on if a valid
100baseTX connection is detected (this LED will not come on if 10baseT is
used).
If the LEDs do not come on as described, there may be a cabling problem or a
bad hub port; if this is the case, try a different cable and/or hub port.
[47] E-connect
Error handling and troubleshooting
B A
137