Oce CS 5090 User Manual page 147

Connection
If for some reason you have to move the machine yourself, please make sure
I
that the mains power point has the right fuse capacity. See the Océ CS 5090
safety data sheet in this appendix for information about maximum current.
Do not bridge any mechanical or electrical circuit breakers.
I
Do not use an extension lead to connect the machine.
I
This equipment has not been designed for connection to an IT power system.
I
(An IT power system is a voltage network in which the neutral wire is not
connected to earth).
For equipment connected via a wall socket: locate the machine close to a wall
I
socket that is easily accessible.
For equipment connected via a fixed connection to the electricity grid: the
I
disconnect device in the fixed connection should be easily accessible.
Surroundings
Do not block the ventilation openings of the machine.
I
Ensure that the machine is placed on a level, horizontal surface of sufficient
I
strength. See the Océ CS 5090 safety data sheet in this appendix for
information about the weight of the equipment.
Ensure there is sufficient space around the machine. This facilitates
I
reloading materials as well as maintenance.
Do not place the machine in rooms which are subject to excessive vibration.
I
Do not place the machine in rooms which are too small and insufficiently
I
ventilated. See the Océ CS 5090 safety data sheet in this appendix for
information about space and ventilation requirements.
General
Always use materials recommended by Océ and developed for this Océ
I
machine. Materials not approved by Océ may result in faults in your
machine.
Do not use the machine when it is emitting unusual sounds. Remove the plug
I
from the power socket or switch off the fixed connection to the electricity
grid and contact Customer Service.
Safety information 147