Choose "Feed Media" Options; Detect The "End Of Media - Oce CS 5090 User Manual

Choose "feed media" options

The printer's 'Feed media' options allow you to:
set the "end of media" detection
I
use the media counter to estimate the remaining media length
I

Detect the "end of media"

'End of media' enables to detect the end of roll, in order to prevent the printer
from printing on the platen unit.
When the media jams or does not unroll properly from the feeder roll, it cannot
advance through the printer. Yet the carriage sensor still detects the presence of
media, and printing progresses. This damages the print job because the printer
continues to lay down ink on the same portion of media.
The "End of media/Feeder stop" option can limit the damage in these cases.
When the printer detects an abnormally long absence of the media loop
between the feeder roll and the platen, it automatically enters the "pause"
mode, as if you had manually pressed "Pause" on the control panel menu.
The printer beeps 3 times every 20 seconds, and remains in the "pause" mode
until you either:
manually press "Pause" to resume printing ("Pause" is a toggle function)
I
manually press "Reset" to abort printing. Abort the print job from the
I
software application as well.
78 Océ CS 5090 User Manual
! ! ! ! Click for Video