Install Cutter - Oce CS 5090 User Manual

Install cutter

With an installed cutter, the printer cuts the media automatically after printing.
Caution:
Attention:
as this can damage the platen and prevent the media sensors from working
properly. However, for heavy media such as canvas, use the "Feed media"
menu to advance the media through the printer before cutting with scissors.
M
To install the cutter
Press Utility Menu/Access Menu/Access Right to move the carriage out from
1
the service station.
Press down the lever of the old cutter to remove it from the carriage.
2
d
[7] Installing the cutter
Push the new cutter into the slot until it clicks into place.
3
Press Utility Menu/Access Menu/Access Home to move the carriage back
4
into the service station. This ensures that the cutter blade is in the home
position.
When the cutter becomes worn, it can cause the carriage to jam or can
Note:
cause a ragged media cut. In extreme cases, you might see an error message
stating "Carriage Axis Failure" (see 'Carriage axis failure' on page 127).
24 Océ CS 5090 User Manual
! ! ! ! Click for Video
Be careful when handling the cutter to avoid injury.
For normal media, do not use an external knife or cutter to cut