Oce CS 5090 User Manual page 127

M
To check cutter
Turn off the power.
1
Clean the inside of the black belt using alcohol and a lint-free cloth.
2
Push the carriage back and forth to access all areas of the belt. Manually push
3
the carriage completely to the left to force the cutter to drop.
Turn on the power.
4
Check that the service station lowers. If not, push it left and then down, in order
5
to disengage the cutter.
If the cutter is worn, replace it. The cutter wear depends on the frequency of
6
use and the type of media cut.
Carriage jams
Check for paper jams or blockage.
I
Carriage axis failure
This may be caused by using matte paper which may curl and cause carriage
I
axis failure. Be sure to use inkjet quality media.
An obstruction in the path of the carriage assembly hindering the carriage
I
movement, which you may or may not see.
Other common causes include dirty encoder strip, media interference, worn
I
carriage bushings, cutter malfunction, and loose trailing cable connection.
Error handling and troubleshooting
! ! ! ! Click for Video
127