Oce CS 5090 User Manual page 90

If you are working in a cold or dry environment, try turning the heat up for a
larger dot size. If the heat is turned up too far, the ink may run or sputter. If you
are working in a humid or hot environment, turn the heat down for a smaller
dot size.
You can set preheat values for each cartridge in the Left and Right cartridge
sets. The following example sets the preheat value for cartridge 4 of the Left
cartridge set.
M M M M
To set the ink preheat value for cartridge 4 of the left cartridge set
Press 'Setup Menu/Ink Option Menu/Ink Preheat Menu/Left/4 Preheat'.
1
Choose a preheat value.
2
Press 'OK'.
3
The following example sets the preheat value for cartridge Y of the Right
cartridge set.
M M M M
To set the ink preheat value for cartridge Y of the right cartridge set
Press 'Setup Menu/Ink Option Menu/Ink Preheat Menu/Right/Y Preheat'.
1
Choose a preheat value.
2
Press 'OK'.
3
Changing the preheat setting will change the drop size and therefore the
Note:
colour appearance. In order to avoid colour changes perform a colour
calibration / linearisation on your software (OGSL or OCC, for instance).
90 Océ CS 5090 User Manual