Scanning; Memory Scanning; How To Skip (Omit) A Channel During Memory Scan Operation - Yaesu FT-65R Advance Manual

Scanning

Memory scanning

Memory scanning is likewise easy to initiate:
1. Select the Memory mode by pressing the [ V/M] key, if necessary.
2. Press and hold either the [▲] or [▼] key to initiate upward or downward scanning,
respectively.
3. When the scanner encounters a signal strong enough to open the squelch, scanning
will halt temporarily; the decimal point of the frequency display will blink during this
"Resuming" condition.
4. Scanning will then resume according to the Scan-Resume mode selected in Set Mode
"25 RESUME" (See Page 36).
5. To cancel scanning, press the PTT switch or the [ V/M] key.

How to Skip (Omit) a Channel during Memory Scan Operation

Some continuous-carrier stations like a Weather Broadcast station will seriously impede
scanner operation when using the "Carrier Drop" Scan Resume mode, as the incoming
signal will not pause long enough for the transceiver to resume scanning. Such channels
may be "Skipped" during scanning, if desired:
1. Press and hold the F key to enter the Set mode.
2. Press the [▲] or [▼] key to select Set Mode Item "28 SKIP".
3. Press the F key to enable adjustment of this Set Mode Item.
4. Press the [▲] or [▼] key to select a channel to skip,
and then press the F key.
The selected Memory Channel will be inversely
displayed by black.
5. Press the PTT switch to return to normal operation.
When the "skipped" memory channel
is manually recalled, the "
icon will appear below the memory
channel number, indicating it is to be
ignored during scanning.
FT-65R/FT-65E Advance Manual 17
"