Turning Off The Transceiver Automatically (13 Apo); Limiting The Continuous Transmission Time (14 Tot); Setting The Pin Code For The Bluetooth Headset (15 Bluetooth Pairing); Setting The Geodetic Reference System (16 Gps Datum) - Yaesu FTM-100DR Operating Manual

Turning off the transceiver automatically (13 APO)

You can set the transceiver so that it automatically turns off if you do not perform any
operation for the designated time.
For details, see "Using the APO function" on page 94.

Limiting the continuous transmission time (14 TOT)

You can set the transceiver so that it automatically returns to receive mode after
continuously transmitting for the designated time. (TOT...Time-Out-Timer)
For details, see "Using the TOT function" on page 95.
Setting the PIN code for the Bluetooth headset
(15 Bluetooth PAIRING)
When a Bluetooth unit is installed in the transceiver, it may identify and be paired with
the Bluetooth headset in use.
See "Identifying the Bluetooth headset" on page 155.

Setting the geodetic reference system (16 GPS DATUM)

You can set the geodetic reference system used for the GPS function positioning
reference.
1
Press and hold
The Setup menu appears.
2
Rotate the DIAL to select [8 CONFIG], then press
.
3
Rotate the DIAL to select [16 GPS DATUM], then
press .
4
Rotate the DIAL to select the desired geodetic
reference system.
1 WGS-84: To use the global geodetic reference
system for positioning. This is the
standard used all around the world.
2 TOKYO MEAN: To use the Japanese geodetic
Tip The default setting: 1 WGS-84
for over one second.
reference system for positioning.
Reduces the chance of
inaccuracies while positioning in
Japan (Tokyo).
Setup menu operations: 8 CONFIG
141