Automatically Turning Off The Power Apo Function; Restricting The Continuous Transmission Time Tot Function - Yaesu FTM-400DR Operating Manual

Setup Menu

Automatically Turning Off the Power APO Function

The FTM-400DR can be set so that it turns off automatically if you do not operate it for
a certain period of time. You can change the time until the FTM-400DR is turned off
automatically Use this function after setting the clock, referring to [Setting the Clock
(See page 21)].
1
Press and hold M over 1 second.
The Setup Menu appears.
2
Tap [CONFIG].
3
Tap [13 APO].
The APO setting screen appears.
4
Tap [–] or [+] to adjust the time.
Specify the time until the FTM-400DR is turned off
automatically in steps of 30 minutes.
OFF / 30 min / 1 hour to 12 hours
5
Press and hold M over 1 second.
The Auto Power Off function is set and the screen returns to the previous one.
Reference • Factory Setting: OFF

Restricting the Continuous Transmission Time TOT Function

The FTM-400DR can be set that it automatically returns to reception state after
performing continuous transmission for a certain period of time. Accidental transmission
of unnecessary radio waves and unwanted battery power consumption can be
prevented (time-out timer function).
1
Press and hold M over 1 second.
The Setup Menu appears.
2
Tap [CONFIG].
3
Tap [14 TOT].
The time display for TOT appears in orange.
4
Turn the O to set the time.
Turn the O to set the Time Out time in steps of 5
minutes.
OFF / 5 min to 30 min
5
Press O shortly.
The time is set and displayed in green.
6
Press and hold M over 1 second.
Returns to the previous screen.
Reference • Factory Setting: 5 min
68
FCC ID: K6620345X40
IC: 511B-20345X40