Transmission Errors - Muratec MFX-2500 Field Engineering Manual

R.4.4 The receiving fax machine has reached its memory capacity.
R.5.1 DCN was received instead of RR during ECM communication.
R.5.2 Line noise or other problems prevented ECM reception.
R.8.1 A compatibility error occurred.
R.8.10 Line noise or other problems prevented line probing.
R.8.11 The fax machine timed out while waiting for the retrain signal.

Transmission errors

T.1.1 T1 time-out. The remote fax machine didn't respond to your machine. This usually occurs
during a manual transmission or when an incorrect number was dialed. Call someone at the
remote machine.
T.1.2 The fax machine's page counter detected a possible document feeder error. Carefully put the
document back into the feeder and try the call again.
T.2.1 CFR or FTT was not received from the remote machine. Either the phone line disconnected
during fax communication or transmission became impossible due to bad phone line
conditions. Try the call again. It may be necessary to increase the output levels on Machine
Parameter A:1. The receive machine may also have closed network or block junk fax
enabled.
T.2.2 The two fax machines were incompatible. No mailbox at receiver or security transmission is
enabled.
T.2.3 FTT was received from the remote machine at 2400 bps. Bad phone line conditions made fax
communication impossible. Conditions can change rapidly, so try the call later. Turn on the
echo protect tone on Memory Switch B:0. Also adjust the interval between DCS and TCF on
Memory Switch B:1. If the problem persists, try increasing the output levels on Machine
Parameter A:1.
T.3.1 The page counter in the fax machine detected a document feeder error during transmission.
Carefully re-insert the document into the feeder and re-try the call.
T.3.2 The fax machine didn't detect the silence period for ending channel.
T.4.1 No response to MPS/EOP/EOM. Poor phone lines caused the receiving unit to disconnect.
Adjust the interval between CFR and data on Memory Switch B:1. Try increasing the output
levels on Machine Parameter A:1. It may also be necessary to adjust the transmit speed on
Memory Switch B:0.
T.4.2 RTN was received from the remote machine. After transmission began, poor line conditions
developed. Try the call again. Attempt the solutions described for the T.4.1 error.
T.4.4 Poor line conditions prevented transmission. PIP was received. The transmission was
interrupted by the call mode. The receiving unit may be experiencing problems. Try the call
again.
T.5.1 No response to RR from the remote machine. Line noise or other problems prevented ECM
transmission. Increase the ECM response time on Memory Switch B:2.
T.5.2 No response to CTC. Line noise or other problems prevented ECM transmission. Increase
the ECM response time on Memory Switch B:2.
T.5.3 EOR was received from the remote unit but further transmission was not possible. Adjust
Memory Switch B:5 for this problem.
T.8.1 A compatibility error occurred.
T.8.10 Line noise or other problems prevented line probing.
T.8.11 The remote fax machine didn't complete the equalizer training phase.
4-20