Adf Motor - Muratec MFX-2500 Field Engineering Manual

5.2.13 ADF motor

1. Remove the platen top cover. (See 5.2.9.)
2. Disconnect the connector of the ADF motor.
3. Remove two springs.
4. Remove five screws ADF motor.
Thin spring Thick spring
ADF motor
Note: When reassemble the ADF motor, follow the instructions below:
1. Attach the ADF motor with five screws loosely.
2. Attach the thick spring.
3. Secure the three screws shown with A in the illustration.
4. Attach the thin spring.
5. Secure the two screws shown with B in the illustration.
Note: Confirm the belt is not loose.
Thin spring Thick spring
B
A
B
A
ADF motor
A
5-28