Adjustment Of The Platen Cover Position - Muratec MFX-2500 Field Engineering Manual

5.3.15 Adjustment of the platen cover position

Adjust the platen cover to pass the document properly.
1. Confirm that the hinge L is set at the proper position.
Also confirm the difference between platen cover and the left cover at front and at rear on the side.
2. Turn the hinge plate to set the platen cover and left cover to be parallel.
Adjust the installation position on the side of the hinge R.
If the front side of the platen cover shifts to the left, turn the hinge plate to set the large number at the
front.
If the front side of the platen cover shifts to the right, turn the hinge plate to set the smaller number at
the front.
Note: Refer to the "Reassemble the platen cover assembly" on the page 5-33 for installing the platen
cover assembly.
Platen cover assembly
Left cover
Hinge spacer
5-96
Pin