Clear Life Monitor; Set Service Code - Muratec MFX-2500 Field Engineering Manual

2. Press [Enter]. The DRAM will be cleared.
Note: To finish the operation without performing initialization, press [Cancel].
3. After clearing, turn the power OFF and ON.

3.16 Clear Life Monitor

The life monitor keeps a count of the pages scanned, printed, and transmitted. This mode clears these
counters.
1. Press MENU, *, H.
2. If the passcode is set, enter the passcode and press [Enter].
Otherwise, proceed to step 3.
3. Press [Enter]. The counters will be reset and the machine will return to standby.
Note: To finish the operation without performing initialization, press [Cancel].

3.17 Set Service Code

This is the code which, one can protect the life monitor clear operation. If it is not necessary to protect to
the life monitor clear operation, abort this operation without entering the passcode.
1. Press MENU, *, J.
2. If you will modify the passcode, enter the old passcode and press [Enter].
If you will set the passcode for the first time, proceed to step 3.
3. Enter the desired four-digit numbers for the new passcode.
4. Press [Enter].
Note: To set the passcode at off and return to normal life monitor clear (not protect), change the code to
0000 by repeating steps 1-4 and entering 0000 in step 3.
or
or
3-140