Muratec MFX-2500 Field Engineering Manual page 151

Memory Switch A:0 - Dialer
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 DIS detect time after dialing
0: 55 sec
1: 70 sec
2 1 CED detection
0: No
1: Yes
1 1 Dial tone detection
0: Do not dial
1: Dial
0 0 Phone line type
0: PSTN
1: PBX
Memory Switch A:1 - Dialer
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 PBX mode dial pause
2 0
1 1
0 1
Adjust
Sets the time DIS signal is detected after dialing a
number.
Can be use to ignore CED detection if noise on the
telephone line is mistaken as a 2100 Hz CED
signal.
Determines if the machine proceeds with dialing or
indicates an error if no dial tone is detected within
five seconds of going off-hook.
When set to PSTN, the machine checks for dial
tone and acts according to the setting of memory
switch A:0, bit 1. When set to PBX, the machine
always dials a given number of seconds after going
off-hook. Memory switch A:1 sets the number of
seconds.
Adjust
Sets the number of seconds the machine waits
before dialing when memory switch A:2, bit 0 is set
to PBX mode.
Switch 3 2 1 0
3-80
Usage/Comments
Usage/Comments
Pause time
0 0 0 0 0 sec
0 0 0 1 1 sec
0 0 1 0 2 sec
0 0 1 1 3 sec Initial setting
0 1 0 0 4 sec
0 1 0 1 5 sec
0 1 1 0 6 sec
0 1 1 1 7 sec
1 0 0 0 8 sec
1 0 0 1 9 sec
1 0 1 0 10 sec
1 0 1 1 11 sec
1 1 0 0 12 sec
1 1 0 1 13 sec
1 1 1 0 14 sec
1 1 1 1 15 sec