Adf Registration (Top) - Muratec MFX-2500 Field Engineering Manual

5.3.5 ADF registration (top)

Adjust so that width A on the copy falls within the following range.
Specification
20 ± 1.3 (mm)
Adjustment procedure
1. Load the A3-sized paper to the cassette.
2. Use the Unique Switch F:2 to adjust the printing margin to 0 mm. (Press MENU, [, 4. For detail, see
page 3-114.)
3. Place the Muratec Test Chart No. 99-2 in the ADF.
4. Make a copy of it on the A3-sized paper with 100 % magnification.
5. Check to see if width A on the copy meets the specifications.
If width A falls outside the specified range, perform the following steps to make the adjustment.
6. Entry the Machine Parameter mode. (Press MENU, [, 0. For detail, see page 3-2.)
7. Adjust the setting of Machine Parameter B:3 to meet the specification.
If the width A is shorter than specification, increase value.
If the width A is longer than specification, decrease value.
Important: After adjustment, you must re-enter the setting of Unique Switch F:2, you changed in step 2.
A
Adjustment Tool
Machine parameter B:3
5-85
Test Chart No.99-2
Setting Range
– 10.71 to 10.71 (mm)
(0.17 mm step)